top of page

SafeCoat® TBI: Spray Foam Insulation Thermal Barrier

​CAN/ULC S145/CAN/ULC 9705
Use: Spray Foam Insulation
• 10-Minute Thermal Barrier (Alternate to: OSB, MDF, Plywood, Fibreboard) 
• NFPA 286: PENDING
• 15-Minute Thermal Barrier (International Building Code Requirement​) 

(CAN/ULC S145: Standard Method of Test for the Evaluation of Protective Coverings for Foamed Plastic Insulation - Full-Scale Room Test in accordance with CAN/ULC 9705: Fire Test - Full-Scale Room Test for Surface Products)

Technical Data Sheet

SafeCoat® TBI Thermal Barrier Intumescent

Safety Data Sheet
 
News Release
 

INTERIOR FIRE RETARDANT
THERMAL BARRIER INTUMESCENT
• for use directly on Spray Foam Insulation
• provides the required thermal barrier
  as an 'alternative solution' for use in
  combustible construction where the
  below substrates are specified on foam
  - 11.7-mm Oriented Strand Board (OSB)
  - 13-mm oak-veneered plywood
  - 13.13-mm spruce plywood
  - 11.9 DF plywood
  - 13-mm particleboard
  - 13-mm insulating wood fibreboard

NOTE: The SafeCoat® TBI performed
greater than 10 times better over spray foam than any of the above NBC approved substrates.

SafeCoat TBI Picture.png

SafeCoat® Quality Control Form
Applicators: This Quality Control Form is required upon completion of your project.

bottom of page